Ultrasonic Inspection

Level 1/2, Ten Day (80 hour) Course

COURSE DESCRIPTION

This 80 hour course covers all theoretical aspects of the ultrasonic method including application skills, defect sizing, immersion techniques and calibration. It is supported by providing 50 per cent practical sessions and lectures on the latest developments.

COURSE CONTENT

• Aerospace product technology.

• Introduction to ultrasonic inspection.
  

• Generation and detection of ultrasonic energy.
  

• Propagation of ultrasonic waves in material.
  

• Sound distribution from crystals.
  

• Behaviour of ultrasound at materials interfaces.
  

• Probe design operating frequency and identification.
  

• Ultrasonic flaw detector principles.
  

• Practical applications.
  

• Immersion techniques.
  

• Defect sizing.
  

• The writing of reports and development of procedures.
  

• Calibration and performance checking of equipment.
  

• Other ultrasonic testing methods and latest developments.

LEARNING OBJECTIVES

1. At the conclusion of this course the student should be able to:

2. Describe the basic principles of the ultrasonic test method;

3. List several applications of the ultrasonic test method;

4. List the types of discontinuities detected with the ultrasonic test method;

5. Describe the cause and effect of various types of discontinuities;

6. Describe the operational steps in the ultrasonic test method and understand the importance of each step;

7. Perform ultrasonic test method, following a written procedure;

8. Interpret and evaluate the test results with respect to the applicable standards;

9. Complete the required test reports, and prepare a clear and concise written instruction (Procedure);

10. Locate defects in various aircraft materials, components and structures with a high probability of detection; and

11. Pass the end of course test.